PV module layout
- Martin Kaleta
With the full occupancy you can automatically create modules to drawn areas. All objects except areas and cutouts are hidden in this mode for a better overview. You can select exactly one area to be used for the full occupancy. As soon as you have selected an area, all other areas will be hidden.
An area can only be occupied with modules once. If you want to apply the full occupancy once again, the existing modules will be removed first.
After an area has been occupied with modules, the area and its cutouts are locked for further editing.
Occupancy modes
There are 3 different types/modes of occupying areas with modules. For all types of occupancy, you are initially in a preview mode in which changes in the module settings are immediately applied to the preview. The modules are not actually created until you confirm by clicking the green tick button. You can exit the assignment at any time via the red button. After the modules have been created, you can delete individual modules or the entire module group via the graphic or tabular view. It is currently not possible to subsequently move individual modules.
Full occupancy
The full occupancy is used to occupy areas with the maximum number of modules considering the current module settings. Please note that cutout regions and regions with other modules cannot be occupied with modules.
|
|---|
| Vollbelegung |
Single module
You can create individual modules in the single occupancy mode by clicking in the area. As long as the preview mode is active, you can move the module freely within the area.
|
|---|
| Einzelbelegung |
Module group
In the module group mode, you can draw a rectangle within the selected area. Similar to full occupancy, this rectangle is automatically occupied with the maximum number of modules considering the current module settings. This mode is mainly used to lay out only a part of the selected area.
|
|---|
| Gruppenbelegung |
Module settings
The module settings can be used to adjust the most important values for the occupancy. The settings are applied immediately to an active occupancy. The values that can be set include:
- Module from the favourites
- Horizontal and vertical alignment within the area and the assembly of the modules
- Distances to the edges of the selected area and between the single modules
|
|---|
| Modul settings |
