Heating usage profile

In the heating profile, the operating times, the setpoint curve and the convective part of the heating system are defined. The heating system can be activated or deactivated by setting the corresponding status for the individual hours. It is also possible to mark and change several hours at the same time.

If the heating system is deactivated, no heating will take place. The heating load/heating capacity during these hours is set to zero. For the heating system, the convective component must also be specified. If this is unknown, 50% must be entered here. The setpoint is defined hourly, so you can create any setpoint daily course. To keep the setpoint, the heating must also be active at this time. The setpoint course of the heating must not collide with that of the cooling. If the heating setpoint is greater than the cooling setpoint, it is set to the cooling setpoint.